|
POLLATUM
HT-105 is a corrosion protection and waterproofing
tape system specially developed for use in high temperature
applications. It is ideal for paperwork or below ground,
underneath pipe insulation or for pipes laid in concrete. Pipes
wrapped with POLLATUM HT-105 is easily, due to
its' distinctive red-brown colour.
POLLATUM HT-105 is
a very versatile, highly conformable and easy to use, cold applied
tape system, that requires no special treatment before application.
It is available in 10 metre length rolls in widths of 50mm, 100mm
or150mm. POLLATUM HT-105 is conveniently packaged with rolls
individually wrapped for storage.
POLLATUM HT-105 consists
of anon-rotting synthetic fabric, impregnated with a special
blend of petrolatum and mineral fillers. There is a plastic backing,
which facilitates handling application. Depending on the soil
conditions, if an outerwrap is required, we offer POLITT 75/10.
| TECHNICAL
DATA |
Temperature
Range:
|
Application:
+50 to +450C
In Service: +Up to 1000C |
| Thickness |
1.15mm |
| Roll Length |
10
metres |
| Tape Widths |
50mm,
100mm and 150mm as standard |
| Weight |
1.35
kg/m2 |
| Breaking
Strength |
200
N/50mm min. |
| Breakdown
Voltage |
16kv
min. |
| Colour |
Red-brown |
NOTE: The typical
data shown is intended as a general guide and is based on tests
carried out under controlled conditions. For further information
on specific queries and performances, Pollyaim should be consulted.
APPLICATION METHOD:
Surface should be thoroughly cleaned, taking care to remove loose
rust, corrosion products and coating debris. Surface should
then be blasted to SA2.5 to get optimum results or wire brushed
to ST2finish.
Start applying the tape with a
full circumferential wrap, applying adequate tension, ensuring
that the tape conforms to the substrate surface and at the same
time,ensure that there are no voids. Wrap spirally as required,maintaining
the necessary tension and allowing for a minimum1" overlap
(or a 55% overlap to achieve a 2.3mm thickness).Continue wrapping
in this manner until complete. When tape rolls need to be joined,
ensure that the overlap is sufficient between rolls to provide
continuous protection. If soil conditions warrants additional
mechanical protection, then over wrap thePOLITT-75 Outerwrap,
allowing for a 1" or 55% overlap,depending on thickness
required.
Our range of pipeline protection products and
services is as follows:
- Pollycote Tape- Self Adhesive Tape with PE
or PVC Carrier and Bituminous Adhesive Compound
- Politt Tape- Line Travel, Primer Activated Tape,
with PE carrier and Butyl Rubber Adhesive
- Pollatum - A Petrolatum based corrosion protection
tape
- Rockshields - Plastic and Non Plastic Rockshields
- Pollyseal - Waterproofing Membrane
- Pipeline Inspection and Wrapping Machines
|